CLEANPLAST 

Epoxy glazing For containers and term enters for beer

 

GENERAL DESCRIPTION

 

CLEANPLAST is an epoxy product for extra thick finishes. The product, made up of liquid epoxy resins and, inorganic pigments, is free of solvents and permits the application of high thickness values per each layer.

CLEANPLAST, hardened with the appropriate LR HARDENER, forms odourless, tasteless coalings, free of porosity and with the following general features:

- Increased surface hardness

- Maximum resistance to abrasion

- High impermeableness

- Suitable for contact with aggressive liquids

- Suitable for contact with foodstuffs. The coating after undergoing tests provided for by the relevant legislation on the subject turned out to be in full compliance with the requirements (D.M. 21/3/73 Suppl. C.U. n. 104 of 20/4/73 and subsequent.)

 

FIELDS OF APPLICATION

Product recommended for the coating of the inside of cisterns and tanks in iron, steel, concrete, etc. designed to contain beer.

 

COMPOSITION

Inert, inorganic pigments dispersed in appropriate binder based on liquid epoxy resins, free of solvents, which are hardened by reaction with an epoxy-polyamide adduct.

 

PACKAGINGS

- CLEANPLAST Kg. 15 - LR HARDENER Kg 4.5

- CLEANPLAST Kg. 5 - LR I HARDENER Kg 1.5

COLOURS Yellow, red and white.

TECHNICAL SPECIFICATIONS CLEANPLAST:

- Type of binder:     Formulated with liquid epoxy resins to the equivalent epoxy 180-200;

- Viscosity:              Thixotropic

- Specific weight:     Cleanplast 1500 +/-50 g/d cubic meters each. (at 20°C)

- Solventd:               not present

 

LR HARDENER

- Composition:        aromatic amino-epoxy adduct

- specific weight:     110 +/- 1150 g/l (at 20°C)

- Amino index:        275 - 290

- colur                    gardner 18

- viscosity               3000 cps (25°C)

 

APPLICATION STANDARDS

 

APPLICATION:

Air-less, brush, roller. In the case of particularly cold temperatures or for the need of more fluidity, warm the CLEANPLAST in warm water at a temperature of40-50°C before adding LR HARDENER.

 

RATIO OF USE:

CLEANPLAST      100 parts in weight

LR HARDNENER   30 parts in weight

Accurately mix the two components and apply with the desired method. Optimal results arc obtained applying the mixture without diluting. If necessary dilute with max. 10% of ethyl alcohol or appropriate thinner A

Pot life                                  : 1 hour;

Average thickness                 : 350-400 microns (in particular cases up to 700 microns);

Drying at 25°C                      : dust dry   : 10 hours

                                              : complete : 24 hours

 Average practical yield          : 1.9-2.1 m3/Kg (thickness in micron)

 Appearance of the film          : glossy

 

USE ON CONCRETE OR PLASTER

1) Remove parts not perfectly anchored or powder through sandblasting or brushing.

2) Application of a coat of Epoxidro as undercoat and anchoring agent for the following coats.

3) After 12-24 hours apply CLEANPLAST in a ratio of 200-250 microns per coat to the desired thickness.

 

USE ON CARBON STEEL:

1) Degreasing and removal of calamine and oxides through sandblasting or brushing.

2) Application of CLEANPLAST in the ratio of 150-200 microns per coat to the desired thickness.