EPOXIDRO 3C
Description:
Three-component primer based on epoxy resins, hydraulic binders, silica aggregates and special additives, usable on concrete floorings and humid masonry.
| Mixture specifications | |
|
Specific weight Ratio of the mixture (A+B+C) Appearance of the mixed components Mechanism of hardening Film appearance Temperature of application Min. and max. applicable thickness values Theoretic consumption at min. thickness Pot life after mixing Minimum time before covering (at 25°C) Service temperature Adhesion on concrete Resistance to water back-pressure |
1.7+/-0.5Kg/l 1-1.5-3 Spreadable grey fluid Chemical reaction Opaque from 5°to 35° from 100 microns to 2mm 250/3 50 g/m2 1 hour 48 hours from-30°C to+100°C 3.5 N/mm2 10 Bar |
| Properties | High adhesion on concrete floorings, both compact and porous High impermeability associated with permeableness to vapour Optimal barrier to water back-pressure It can be treated with paints and coatings which are both transparent and not, after any time Binding bridge between old coatings (if clean and free of grease) and new paint |
| Applications | Primer for concrete surfaces which are also humid Encapsulation of asbestos Binding bridge between ceramic tiles and epoxy or polyurethane coatings Shavings on humid bases, rapid drying to permit the bonding of parquet |
| Use | The surfaces should be clean, compact and free of .oil, grease and dust. Old resin coatings should be roughened. Proceed with the preparation of the product mixing, with the aid of an electric drill, the base and hardener (A+B) first and adding component C then, respecting the ratio A/B/C = 1 - 1,5 - 3. Mix until completely homogenized. EPOXIDRO 3C can then be applied with spatula, or diluted, by means of brush or roller. Dilutions with water are possible up to 20% of the total mass. |
| Packagings | EPOXIDRO 3C is available in the following packagings Part A (Base) kg 2.5 Part B (Hardener) kg 3.75 Part C (Aggregates) kg 7.5 |
The shelf life in a dry place protected from frost and heat is up to 12 months.
The product should be kept at a temperature between +5°C and +30°C
The above figures, derived from the best of present knowledge, are to be retained purely indicative. Not assuming responsibility of results when these may be influenced by application and environmental elements out of our control. We therefore invite buyers to effect tests to verify the suitability of the product for the desired use.